Search results for query: *

Removed the passenger vent delete plate and installed an original vent and cable and it makes a huge difference. I also half *** fixed the rear door window roller by putting the two halves together and zip tying them, now it functions perfectly. Did the same on the other 3 doors five years ago...

Down to 11,500.

Restorations seemed the best place to post this since there’s no “History” forum. This might be of interest or use to someone on here, the general topic is California Highway Patrol Police Pursuit vehicles, specifically from 1976. I know, in 1976 CHP purchased Dodge Coronets, which are B Body...

I have a 1963 Newport with a 361. From what I've read so far, all 361's came with a 727 Trans. Will any 727 Filter work, or do I need to figure out what specific flavor of 727 I have?

There was a guy here in IN that had collected Chrysler TC-Maseratis and had one in every color. When he went to sell them, you could kinda tell by his FB ad that he was bat-**** crazy.

Looks like someone bought the Ron Francis wiring kit to fix the 'junk' Chrysler wiring and didn't finish the job. It's junk wiring now, for sure. Only the bravest of souls would gamble on this Humpty Dumpty.

http://www.brewersperformance.com/proddetail.php?prod=CRB818NOS

This is a link to an aftermarket with the correct original part number 2260 021. Mopar called it a release fork seal. 1965 Dodge Dart Manual Transmision Clutch Fork Rubber Boot 2260021 MoPar USA | eBay

I bought this a while ago for my 73 Fury. Of course it didn’t fit… it was advertised as a 69-73 blower motor switch. Is there a difference for heater vs air conditioned cars? I don’t need it, so I will be posting it for sale once it is correctly identified. Thank you.

Looks correct. Looks correct. They are also available aftermarket. Check my answer on Moparts - ebay link has the newer part number that works.

as the lever only has a limited amount of travel on the wheel you are using, if it won't stay tight enough in the locked position, you just screw the bottom "wheel" in a touch, then re-attach the lever with the three screws shown in three other holes that align with the adjuster slot in the...

.

I have 12 in good shape with the screws - four have the locator pin missing-but easily remedied by drilling them out and using a small screw as a substitute. How does $50 shipped sound?

Nos 1974-75 Chrysler ammeter part # 3592450. $25 plus shipping from 40165. Thanks

How does that perform an "adjustment"? I'm intrigued.

$200

Join me in welcoming @Nova2 to FCBO.

those locking levers can also be adjusted somewhat by removing the three screws shown, and moving them over a hole or two on the round piece below them that presses on the locking rod. i have had many of those columns apart, and i actually built a tilt/telescope column with a removable steering...

color is b5 blue which was a factory color. But apparently it´s been repainted and either very bad or in a somehow matte finish which of course is wrong. I would very closely inspect for bondo and rust. Front seats are redone, you can see that the leather is also kinda matte and not as shiny as...

Taillights look good. I’ll pull them off and get a closer look