Search results for query: *

  1. J

    FI pump in tank

    No clue on the B Tank, but there are threads covering that. I used the original C tank. interesting that you found them to be the same depth (top to bottom) the B body pickup is in fact a bit different, if the tanks were the same top to bottom the senders, I would think, would be the same too
  2. J

    FI pump in tank

    Hey all, figured I'd give a bit of an update. The 69 B Body Holley In tank pump does in fact work! Just a little bending of the hard line on the pump to make if sit on the floor of the tank, it picked up fuel with 1/2 gal in it. The down side is that the float is way off, I tried a few...
  3. J

    Swapping in a 46rh trans

    Found an old article this morning while I was sitting on a conference call. The part that really helps is the measurement from the Engine to Trans mount. https://www.chrysler300club.com/tech/rinalcc/A518%20Part%201.pdf
  4. J

    Swapping in a 46rh trans

    maybe I'm ok with a stock converter....maybe not? I put the stock converter on and sure enough it hits the bell BUT if I pull it back out to where the 727 installed depth is, which is .432" then it seems to be ok with some room to spare. the only real way to find out it to actually install...
  5. J

    Swapping in a 46rh trans

    or maybe not...you got me thinking. They will accept an 11" converter, but the stock one is just a tad over that. Always something isn't it.
  6. J

    Swapping in a 46rh trans

    11" works which is the stock lockup size
  7. J

    Swapping in a 46rh trans

    Did you fab your own? Have any specs on it?
  8. J

    440 No Oil in Top End

    Was any work done on this engine prior to this issue? Rebuild? Almost sounds like front galley plug missing.
  9. J

    Swapping in a 46rh trans

    Finally getting around to doing the swap. Since the 46RH is a small block only trans you have to either do a spacer kit ot a bellhousing swap to fit a BB. I'm doing the Ultra-bell swap. There's some detail not fully explained in the instructions and not on YouTube so thre a quick video...
  10. J

    For Sale Mopar magnum valve covers

    New never installed. $300 Shipped. includes grommets, breather, oil filler cap etc. Shipped from montana.
  11. J

    SOLD Power Brake booster

    $125 shipped. 67 drum booster from my 67 Fury. Works perfect, no rust. I converted to disk hence why I don't need it.
  12. J

    FI pump in tank

    they keep this old guy in shape. It's weird being oldest guy on the mountain lately.....ugh...
  13. J

    For Sale 67 Fury Body side and wheel well Trim (Full Set)

    I have the full set front to back/ both sides off my 67 Fury III, one front fender passenger side trim as a good ding in it but is fixeable. the wheel well trim has wear and tear but nothing missing. There is some overspray on it from a previous crappy re-paint, but it can be cleaned off...
  14. J

    440 owners - a question

    exactly what carb are you using and what settings and jets are in your carb? when at idle what vacuum are you pullling? One note. Backpressure is a bad thing, I don't care what you think, engines don't like it. it's an air pump. and to add to that, if you have remove backpressure...
  15. J

    FI pump in tank

    Have some info. I bought a pickup/Sender for a 68 B Body for comparison. It's close with a small tweak I thin it would work so I decided to pull the trigger on a Holley in tank unit for 68 B body. It seems like the B body tank may be a little deeper from the mount, maybe 1/2 to 3/4". The...
  16. J

    Convertible Seals: Steele Rail Weather-strip Set

    Weird. Pictures of the areas I showed above please.
  17. J

    46RH/A518 Crossmember Mount

    Anyone that's done it. what did you all do for the rear crossmember move? Modify the original? and if so, how much fab was needed?
  18. J

    Convertible Seals: Steele Rail Weather-strip Set

    you won't be able to use bulk material for the Conv top front rail, it's a complex piece with corners etc. The front along the top of the windshield is flat then it tapers a bit to the corners and has a bend there where it starts to go backwards along the Vent frame and then the side window...
  19. J

    Ezoic adverts

    I'm on a few other forums I pay for, it ads up. I'm good, consider this thread dead.
Back
Top