Search results for query: *

It's my car. Kevin

Eastern Ontario. Kevin

This one could be had but it's a good bit better than a project. A 44k mile Time Capsule/Survivor that needs a trip to the Detail Shop and the nylon Safety 99 Motomaster bias ply tires swapped for some new radials. Original L84 size spare still in the trunk. Kevin

My Dad's 75 Gran Fury had a 360/904 and I suspect if the Heavy Duty/Tow Package box didn't get checked on the order sheet, most SB C's got the 904. The one in my Dad's GF was out 3 or 4 times under warranty and the 904 in the 69 Belvedere that preceded it probably twice that before they...

The correct fill tube Oring is actually flat sided, not round. The hardware store round profiled rings pretty much always leak, sometimes worse than the original worn out square profile ones do. Kevin

I've rarely seen a pan leaking that loose bolts wasn't the reason. I've lost count of the number of leaking fill tube Orings that drool into the pan rail that make it look like the pan is leaking... Selector/kickdown shaft seals are a close second. Kevin

My understanding is you dial in as much + caster as it will give you first and then hope to have some left when you set camber and toe. It's not unheard of for caster to go negative after setting camber to spec. I think to keep these boats centered up requires a lot more caster than spec'd...

George Carlin sure had it right when he said stupid people in large groups are dangerous... Kevin The hole in the ozone has been there in varying degrees from the beginning. Kevin

Our house is in the path so all we had to do was go out the back door but we went to the PDRA East Coast Nationals in Benson NC this weekend. We're in Myrtle Beach playing tourist today. It won't be a total eclipse here, but it was snowing when we left Thursday so I'm good with 76% and...

Almost the same mileage as my 71. Kevin

Found this Googling that. lol https://harmonclassicbrakes.com/boosters-and-parts/ Kevin

Ferrari 250. Kevin

That looks like a HydraVac type unit from something European. They didn't call it Power Brakes over there, it was Servo Assist or something. What is it on? Kevin

If that's a small block, do not put the trans back in without first replacing the the freeze plugs in front of the flex plate. DAMHIK... Kevin

If it's an OEM type conversion, a lot of the Chineseum "Orange" boxes are notoriously unreliable. Work when cold but die when hot with miraculous recovery once cold again is a recurring theme. I believe the OEM one needs switched 12v to the box, so if it's on the + side of the coil, it will not...

Give Nigel a call. He show both left and right. Cdn $ 1969-73 C Body Left Hand Caliper-Rebuilt – National Mo-Parts Kevin

Trust but verify... lol Kevin

If it's not an out and out scam. Canadian plates in the pics on a Seattle CL ad... Kevin

The 04 is actually a better HP choice in some respects because it doesn't have MDS. All 8 all the time. Later heads, Eagle I believe are better flowing but will bump compression because of smaller chambers. Could be iffy for pump gas depending on camshaft specs if you keep the 04 bottom end...

You're all registered to bid? Kevin