Search results for query: *

Side ones, 1 1/4 inch shallow cup, End ones, 1 inch shallow cup.

The "coat hanger looking stuff" inside cylinder heads is from the sand-casting procedure, they helped keep the mold shaped while the iron was poured. When the sand was removed, the wires stay behind.

After the cam bearing rearrangement, did he test-fit a camshaft to check that it turns freely? At my shop, if a bushing has to be removed, it's not getting put back in. They don't go in a second time with the same "press fit".

Anyone have a measurement for the drive shaft, U-joint c/c, for a 70 Newport, 727 , 8 3/4

@SGT FURY your inbox is full.

Shim gaskets are available. Mr Gasket part # 1135G .020 thickness

Spare tire mount still to be relocated?

There isn't by chance just a piece of crap that has fallen into the intermediate shaft slot and now won't allow the distributor to seat properly?

I can send better pictures if Saskatchewan isn't too far.

. <Here!

Yes, that's Premier Brad Wall's car.

To the OP, maybe you need a road trip!

383 recipe | Page 2 | For C Bodies Only Classic Mopar Forum

@Walter Joy or anyone else searching for these, Felpro doesn't make them, But MrGasket has them, part #1135G.

I pm'ed you. They are available again!

Good job, carry on!

I'm not certain as to if I'm seeing that piston in your post correctly, and for a mock-up it wouldn't matter, but that piston looks like it has specific locations , as installed, with the bigger valve notch provision for an intake valve. I see it as being in the wrong cylinder hole! That one...

Here's an example. This was built somewhere else, now is at my shop, It has 6 hours of running time on it and has a cam failure. What the picture shows is the blow-by past the top ring leaving the sooted stain, if the ring was "rotating" the width of this soot pattern would not have been just a...

At the 7 1/2 minute mark he makes a reference to a miss packaged set of rings for a small ford. NO if there was a ring in the kit for a oversized bore there would have been an end-gap overlap issue, not a extra .030 extra end gap like he said. As for his block deck surface prep it sucks! dowels...

Sure looks like an "HP", even smells like one too!, but no "HP" on the pad.