Search results for query: *

What part of Marin TX9?

If you look down into your carb bores with the engine idling. Do you see any large droplets of fuel falling onto the carb flappers? This would indicate you carb float valves leaking by, Or improperly adjusted floats and will give a rough idle. A torque converter with a low stall will make the...

I work in California. The company I work for gives me money for rental cars when I'm out west, so I just buy old iron and make an adventure out of it when it's time to go home. Reason for selling. Is: I have 9 cars right now. I'm going through a divorce, and I'm closing on a second house for the...

This is a nice '65 300 4 door, 383, 4bbl, 727. The body is in nice shape and straight. There is a crease in the rear passenger side door. It's not too bad. There isn't any major rust on the car. There is some cool looking patina rust where the paint has rubbed through. Floor pans and trunk are...

How much for the satellite back seat?

On the steering gear block. You have to loosen (just barely so as to not blow PS fluid out) the two 7/16" socket head bolts on the valve block your power steering return hose is hooked to. I usually put the front end of the car on jack stands. Then crank the engine and tap the valve block fwd or...

If I turn mine off after a fast paced hyway run it pukes everywhere. Have you tried running at a slow speed for a few minutes before you shut it down? Mine needs a cooldown

Not sure it will fit Your needs. I bought a booster for my 65 300 at autozone.

Just my recent experience with removing the rocker rail (383) from one side. I pulled the rail to install some better spacers. When I put it back on the engine ran very rough. Took me a bit to figure out that the lifters had extended all the way out and hydraulicly locked. I lossened the rail...

Thanks!

The car is a 300. The glove box door doesn't have any aluminum on it. Will snap some pics tomorrow

My glove box door has three holes in it. Looks like an emblem goes there.

If using KB Pistons be extra sure to gap the top piston ring as per instructions. Bad things will happen if the gap isn't large enough. Speed pro makes a forged set for around $400 with moly rings. They are heavier than the KB's and they are flat top. Key word here is Forged!

I was working in San Francisco from Dec till mid March. While there I picked up this land yacht from a 90 year old lady in Hayward California(it was on Craigslist). On March 15th I flew the wife and 11 yr old out and we took a cross country trip back Mississippi in the 300. Route 66 was a blast...

So I am new to C bodies and just joined this site today. I have a B body addiction and have been a member on forebodies for some time now. Please contact me if you have the following items for a 1965 Chrylsr 300 and you wish to part with them. I need the letter "E" for the hood. I also need...

Currently a forbbodiesonly member. I just picked up a 1965 Chrysler 300 my first C body and would like to rely on this sites knowledge and input. Location: Mississippi