Search results for query: *

Ground for horn???

Check similar year Daytona (Pacifica and Shelby Z). Rear discs were offered and Shelby usually repurposed existing parts if possible. Bad news is rockauto did not even have listings for rear calipers, although they did show some rebuild kits. Beat up the innernet and see if you can find a local...

I've been using 8121S on my 70 Chrysler. Also crossed the Napa part back to National..same thing. CR Seal Finder See attached screen shot

Look in your service manual under Lubrication and Maintenance. The lift points are marked in black on the diagrams.

The transponders in the wheel have a battery. I've never seen a factory one with a replaceable battery. Factory figures they'll last around 10 years. On average it fails on the owners dime.

Why not whack the steel tube in the lower shock bushing with a grinder?? Don't go bending your control arms.

The stem on that metering valve must be pulled OUT to open, not pressed in.

I drive my car in any weather except snow(because of the salt). I don't go looking for bad weather but have been caught in the some real storms over the years. Prepare for the worst and anything less is easy. Tires must have good wet traction.

If you could measure the width of the whitewall and post a few pics when you get them I would be most appreciative.

Check the fluid level in the master cylinder reservoir. Low level will turn on lights and disable the system.

@mobileparts

Is the compensating port blocked???? Wrong pushrod length or setting?? Swapped parts can create a load of problems.

@sixpkrt : How goes this project??

Check your fender tag to make sure your car was built with disc brakes.

I'll bet it leads to a need for fresh underwear...

@sixpkrt This is the thread I was talking about. Caliper pics on first page.

Real simple to check.. get a spray straw from a can of brake clean and insert it into each port (see pic). If the one going in the drum side inserts as deeply as the disc side the valve is missing. I went thru 3 masters a few years ago to get one with the valve. A missing valve will give you a...

Compensating ports in master cylinder held closed due to mis-adjusted pushrod length????

I had the same issue. Master was always sweating fluid out after a drive. The leaking master was a replacement I put on in the mid 90's. Original never did this. I chalked it up to the Hipo manifolds cooking it after several hours on the freeway. Tried different lids and tightening up the hold...