Search results for query: *

Sorted!!! thanks to everyone for your help and advice! Short version- bad Earth. so the faults I had were as described. Then I had more issues like the interior cabin lights not working correctly, doors closed and rear lights off but front footwell on then door open the opposite happened...

I will do the harness soon, but in the meantime I would still like to drive it a bit. Frustrating as the night before everything was working without issue! I do have a fire extinguisher handy just in case.

As agreed GRD made no difference. The ignition itself Ohm tested and works correctly. Just batt feed when off, ignition 1 and Acc at position 1 and at position 2 (run) I have Ign2 and St. Voltage testing the ignition connector block it has a permanent 12v feed from batt and also Accessory. So...

Sorry yes GRD. The connector block only has 5 slots whereas the ignition itself has 6 pins. Beside it are 3 loose wires that have never been connected (1 red and 2 brown with white tracer- believe for a blower fan that was removed). GRD never was connected, and it has been working fine like...

Appreciate all your suggestions. No solution yet. fixed a bunch of poor condition wires (coil blue wire in pic). I had another ignition and tried it but no joy. The connector to GND isn’t wired up. Could this be an issue? Also any idea how to jump this with blade fuses to check if it’s the...

There was no fusible link, I just wanted to have a fuse there till I discovered what the fault was (save further damage). Iv got the manual and a good multimeter, just wondered if anyone had some pointers. Iv checked quite a bit of wiring but still found no apparent issues. Run circuit is...

Anyone knowledgeable with voltage? 1967 C body, ran great last night. Went to start today, smoked out the red wire that runs from from the starter relay to the firewall and connected up to the ammeter (no ammeter gauge but as per the wiring diagram). Wire replaced put in line fuse and...