Search results for query: *

It must've been the sensor. I changed it for the original and put my 180 stat back in. Car barely gets above the first E in Temp. Thanks to all who responded!

WELL...this was enlightening! So I grabbed an Ohmmeter, right? The original '66 sender shows .11 on the reading, the new '67 sender shows .22 on the reading! I've checked this 3 times and the readings are consistent! I'm beginning to highly suspect the temp sensor! I'm going to swap in the...

CBody...to best of my abilities, yes, everything was aligned. Actually, I screwed up. The car HAD a 180 stat and that worked pretty well. When I put the car back together, a 160 stat was installed. Thus the 160 degree tank temp. The gauge should not read hot. I'm beginning to suspect the sender.

In my 66 Polara 383, I recently did a timing chain replacement and installed a new water pump hosing which I cleaned thoroughly and replaced the temp sending unit with one from a1967 and up application, which the stud connector instead of the spade. This also eliminated the jumper wire from the...

I agree! Great job!

Mancini Viscous Fan Package I put a setup like this on a 1969 Roadrunner I had replacing the standard fan It worked very well!

Just what I needed 18.5 inch 7 blade fan with a thermal clutch. pn 2585 376 Thanks!

Thank you, because I'm going to need one!

From reading the forum, it seems like 18 inch is the correct size?

Hey folks... The cooling fan on our 66 Polara 500 has had a lot of damage...almost to be expected for an old car. But there is a chunk missing out of the end of each blade and the outer edges appear ground, some are very sharp. Don't know what happened, but it's not pretty. I'd like to replace...

Following...