Search results for query: *

  1. E

    Wiring up a washer switch to also activate the wipers after a delay and keep them on for a bit

    Newer cars usually have the wipers wait a second or two while the washer squirts water onto the windshield before the wipers start up. Then when you release the switch, the wipers will keep wiping for a few seconds after - how can I do that with the stock wiper motor and wiper switch, and an...
  2. E

    DIY: Rewiring the cigar lighter to only run in accessory mode

    Unfortunately for me, the cigar lighter wire is crimped directly to the fuse holder terminal in the fuse box. Fortunately, it was easy enough to add a relay in, and have it activate when the key is turned to accessory mode. Stock cigar lighter socket, with a pink and red wire going into it. A...
  3. E

    66/67 Polara dash ashtray bulb socket?

    What type of bulb socket goes in the hole here? The existing black plastic socket in the harness (has a single orange wire) is too small for it so it just wobbles about.
  4. E

    What terminals are used on the female connector on the back of instrument gauges?

    The female terminals for these particular pins, what are they called and what size are they? They're definitely not bullet terminals. Would they be molex pins/terminals like what was used in older computers?
  5. E

    How to test temp sender and gauge with only a multimeter?

    I finally got my car fired up and man it's a great feeling getting it running again. But unfortunately, I noticed that my temp gauge barely moves from stone cold even though the engine is scalding hot. The fuel gauge works fine, which implies something wrong along the sender circuit. Is there...
  6. E

    67 Fury - door jamb switch and trunk lid switch threads

    Anyone know off the top of their head whether the door jamb switches are the same threads as the trunk lid switch on a 67 Fury? Don't feel like spending 30 bucks + shipping for the trunk switch if the door jamb switches will work. Update: yep, they're the exact same threads.
  7. E

    RTE IVR3 install on a 66 Polara/Monaco gauge

    I've got four eyes but it seems that still isn't enough for me...how do I wire the IVR3 limiter up? The voltage limiter appears to be built into the water temp gauge, I've bent the bimetallic strip back but not sure which terminals to connect the pins on the limiter. My setup is as below: My...
  8. E

    67 Fury - how to remove the front grille turn signal/parking light bulbs?

    Sounds like a dumb question but my car doesn't have the owner's manual to consult, and these seem to be stuck on permanently. Tried all sorts of twisting and pulling but cannot for the life of me get to these bulbs. How do you take the socket off?
Back
Top