Search results for query: *

I recently acquired this 2.76 differential with the intention of swapping it out for the open unit in my NY. This weekend I built a holding jig and started to clean it up a little. I was hoping to just clean and paint, as it seems pretty solid and the backlash is tight. Also planning on...

I'm going to reserve some space here for the rebuild thread because the time is approaching. I was driving back from Christmas last week, cruising down the freeway at about 60, and all of a sudden the engine just cut out. After pulling over, cranking the engine revealed a different sound...

No matter how much I tuned it, it just wouldn't run right. It ran OK, got about 12mpg, had good power on the highway, but ran sluggish around town. Plugs always fouling with oil after a few 100 miles. Compression was perfect - each cyl. at 150 psi dead on. Replaced stem seals, but still oil. So...

Well, the time is almost here to either rebuild my tranny or find a rebuilt unit. It just started giving me the telltale symptoms with a slight engine rev between 2nd and 3rd shifts. I wouldn't expect I've too long before I'm high and dry....and I drive 200 miles per week. If I had it my way...

The trouble light comes on momentarily with hard stopping or cornering. The oil level is halfway between add and full. Obviously there's a problem with the pickup design or lack of baffles in the pan. I've never experienced this with another vehicle. When the light comes on, I shift into neutral...

As I yet don't have a shop manual, and the sticker in the engine compartment is well worn and illegible, was wondering if anybody had tune-up specs for a standard 440 handy? 73 NY'er. I've got a rough idle - rebuilt the TQ carb, replaced the plugs, and now runs better. Next it's onto the...

I am rebuilding the Themoquad carb on my '73 440 and the rebuild kit I got at Napa did not come with instructions or specs. Looking for specs mainly for float setting and other key things before I put this back together. I do not have a factory shop manual yet. If anybody has any specs handy or...