Front Suspension Control Arm Bumper??

[daveydave10]

Any one ever replace these and have a part number for 67 Crown?
I ordered what every store says they are: Moog Part # K200982 but they are not correct. They are similar, but the two mounting holes need to be about a half inch further apart.

 

[commando1]

Any one ever replace these and have a part number for 67 Crown?
I ordered what every store says they are: Moog Part # K200982 but they are not correct. They are similar, but the two mounting holes need to be about a half inch further apart.

Upper or lower? The C's I have seen, they are different.

 

[daveydave10]

Upper or lower? The C's I have seen, they are different.

Lower Bumper. Page 2-10 of the FSM, Figure 12. Big triangle rubber mounted to a steel plate with a mounting hole on each side.

 

[MrMoparCHP]

The factory part number is 2071653
Atlas Obsolete shows it on this page
MOPAR TO ATLAS
I couldn't get to a page that shows it as available or not.
You might want to contact them and check.
Home


Alan

 

[commando1]

Lower Bumper. Page 2-10 of the FSM, Figure 12.

I'm plum out of of 67 Imperial FSMs this week...