WANTED Shifter handle wanted

[Polara_500]

Looking for a shifter handle. It's kind of a composite of the two shown below with the curves of the non console shifter and the console offset at the bottom. Pretty much the front handle shown here with the offset of the back handle.

 

[commando1]

What SPECIFICALLY is the application?
Make.
Model.
Year.
Bench or console.

The ARE out there. Gotta know where too look.
C-body handles are expensive , btw.

 

[commando1]

Better yet.
Cut the two of them below the boot line and combine it by welding. Should take about 30 minutes.

 

[Polara_500]

It would have been 65 console shifted. Have seen them on Monaco's, in fact John has one on his; but I think they came on others also. Have thought about cut/weld and still may, but would rather find a correct one. And I know it's not likely to be cheap. The sucky part is I held one in my hand at a swap meet years ago and for some unknown to me reason, passed on it - that one was also pretty cheap.

 

[commando1]

Cut n weld is my choice.
You're dealing with very thick stock so welding is a pc. of cake.