65fury's latest activity
-
65fury replied to the thread Trim clips.I did try these... They were way to big to fit in the trim. Anyone know where I may be about to get the same kind only smaller? -
I can't exactly remember, but I think that on a 65 Fury the pump sits under the washer reservoir on the inner side of the fender, or...
-
Seems like there is an illustration in the '66 Chrysler FSM? Pump mounts directly below the tank. Outlet line runs in the trough in...
-
Tring to run my windshield washer pump and lines. I have the tank installed but don't know where the pump and lines go. Can someone send...
-
65fury replied to the thread Trim clips.I tried the plastic ones from national mopars. They were too big. Would not fit the trim piece. Back to the drawing board!
-
65fury replied to the thread Trim clips.Any more ideas? These were WAY too big to fit my trim!
-
65fury replied to the thread Trim clips.very funny:lol::rofl:
-
65fury replied to the thread Trim clips.Yeah, That was my Husband...He was making a joke, he got a big kick out of putting that on my feed :) :lol:
-
Since mine is only a FuryII it didn't have these trim, I bought some and didn't want to drill holes, so I glue them, now a day new car...
-
A little more researching and that clip / retainer is available. The correct 1965 style instead of the style used on 1970-71 Barracuda...
-
I checked the 1965 master parts catalog. Here is the information on correct style clips for the door belt molding. The clips are listed...
-
65fury replied to the thread Trim clips.I guess the trim would slide onto the clips after the clips are installed on the car?
-
65fury replied to the thread Trim clips.Thank you. I saw these on a web site but was not sure they were for this type of trim. Will order them and see .
-
Those plastic clips with the center pin are not used for belt moldings. Here's an original door belt molding and clip from a 1967 Dart...
-
