Recent content by Bigasawhale2

Botch this up, here are pictures

Hi, Have a grouping of parts for antenna mounting. Purchased for a 1968 - but is certainly not for this application. Antenna bezel 2926320, only part with part number. Never looks to be installed. Price $20 + Shipping from 14701 (Flat rate box approx $10.40) Kevin

Hi, I have a power seat knob, nice shape. $15 + Shipping from 14701 Suggest USPS - flat rate box - approx $10.40 Best Regards

Antenna Bezel part number 2771954, and retaining clip Not sure of application Very nice shape $10 + Shipping Shipping from 14701 – suggest UPSP flat rate box about $10.40 Best Regards Kevin

Hi, Have rocker clips for a 68: Newport - lower rocker molding (all I have). How about $5 + shipping Shipping from 14701 - suggest USPS flat rate box, I understand about $10.40 Best Regards Kevin

Nice! What kind of fuel pump are you using to feed those, and is loud ?

Hi, I am adding the factory trunk release button: 1968 Chrysler Newport Does anybody have a picture of where the factory put them ? Thank You Kevin

I have taken a bottle jack, with a (2) 2 by 4's (one on back seat wire frame) (another one on front seat), use the jack to push frame & then pull up

Thanks - pot metal is really pitted. I have come across them - but the seller, is often not positive of what they came out of..... I have another set - slightly less rough - but they have two different casting numbers 2664441 LH (Drivers) 2664440 RH (Pass)

Hi, I am looking for replacement vent windows for my 1968 Chrysler 2 Door fast top. By parts book – it looks like the part should be 2860696 - 7 The part number on the castings 2860705 LH (Drivers) 2860704 RH (Pass), I can’t seem to find this number in parts catalog. I realize a casting number...

Hello: I have a 1968 - Chrysler Newport, common to other C Bodies - Driver's side frame rail (do not have pass side) Carefully removed - very good shape. $100.00 Local pick up in Jamestown, New York Best Regards, Kevin

I concur with rd92west....I was able to find a NOS isolator, any moons ago.

I did not through the floor.. I made a nut assy and welded into the upper rail - so tube is linked together. Going thru the stiffening ribs - might work (forget where they lay across) Straight thru the floor sheet metal, i would back up with a plate in interior.

Suggestion, post some pictures Most probable, bracket cant be removed and another bracket can be TIG welded back on

Nice, thank you