I am doing bench test only right now and power only to terminal H. Nothing at all from the other terminals. My wiring diagram shows B2 feeding dome, stop and tail lights. Bought another switch today and will see what happens.
I removed the instrument cluster on my 63 New Yorker to clean it up and replace the light switch since the dimmer was flaky. Installed the new switch, reinstalled and everything works except the dimmer!
Going through the electrical diagram, power goes to tab B1 on the switch, output to...
Thinking of installing seat belts in my New Yorker.
There are no pre drilled holes so wondering if anyone has done this using seat belts from a different year c body or went with new aftermarket seat belts. How do I know where to drill holes for the fasteners etc.
Thanks
Thought I would post this for anybody needing either a new valve or have theirs repaired. I looked around for a while and found Joe who owns heatervalves.net out of Wisconsin. Turnaround time of one day and priced well. I have attached a few before and after picture
heatervalves.net - Home
I was reading that the where the speedometer cable connects to the speedometer at the instrument panel that there is an oil well.
I have attached a picture and was wondering if this is a fact and if so what oil would I use. It looks like the well has a small hole?
Thanks
So I have my instrument panel out from my 63 New Yorker and was going to clean the circuit board but looking at it I am not sure if it has a greenish coating or is it oxidation. The board itself is brown and I can remove the green off ok with rubbing alcohol but cleaning the copper is not so...