Recent content by CR-MOPAR

Drivetrain is long gone. Haven’t decided if I’ll repair my frame or just weld the engine mounts onto the 6cyl frame

Fairly certain it’s still there.

Ok cool that’s good to know. I’ll have to check the car I bought to see if the Zbar is still with it or not. Do you just use the end off of an automatic pedal and graft it onto the manual brake pedal?

Yeah I remember one of the cars had it but it was a slant 6 car so I’m pretty sure it’s different. I bought 3 Fury parts cars last fall for $500. Two 66 318/auto and one 65 slant 6/3 on the tree. Clutch linkages are all missing on the 65 though

I found a few 3 on the trees but they were missing zbar and rods etc. Could have missed one though, lots of cars there. How much was the package to buy?

I’ve stopped in there a few times, he didn’t have any 4spd c bodies when I was there last

Looking for Z bar, clutch pushrod, Fork rod and a hurst shifter handle for a console I know brewers has new/restored stuff but I’m looking for driver quality.

Dang. Thanks for replying

You don’t happen to have any of the 4spd parts from the car do you? I’m mainly looking for hurst handle, z bar, clutch pushrod.

65, 3 on the tree

Cool thanks. I’m picking up a parts car once the snow melts, so I’ll have an extra setup I might sell.

What’s the going rate for a used manual brake, manual trans pedal assembly? (65/66 C body)

Do you know what years this would be from?

True. I know how that would go though, I’d end up wanting to fix it and the one I have already. Plus I’m only into mine for $400. I should be able to find most my missing parts without too much issue. However, the shifter, Zbar, linkages etc that I’m missing will cost some coin.