Recent content by Jayvan1967

I adjusted the throttle linkage how the service manual tells you. When I shift it manually from 1st to 2nd to drive it does shift to third now. The shift to third seems to be really soft compared to the 1st to 2nd. But it is shifting. I will be trying to adjust the shift cable in a couple of...

Thanks for the replies. Hoping for one at least in the Midwest.

Looking for a solid hood for a 1963 Chrysler Newport. I believe a 1964 would work also. Preferred one close to Nebraska, because of cost to ship. thanks

I will look at the shift cable. I have noticed that when I take it out of park, it will sometimes want to creep forward when it is in neutral. thanks

Have a 1963 Chrysler Newport. Been sitting for 25 years. Transmission shifts good into reverse, 1st and 2nd. Does not want to shift into 3rd gear. Fluid is at the right level. Searched other forums and it seems the most common failure would be the seal on the 1st/reverse servo. It that the...

Now it says your privacy settings will not allow private message. If I could message you, I will give you my cell number and you can just text the pictures.

Could I get some pictures of the floor boards and the frame rails? Tried to send private message but it says your mailbox is full. thanks

Thanks for the info. So the lip over the wheel is different?

I am restoring a 1960 Plymouth Fury 2DR hardtop and wondering if the rear quarters and back half of the wheel lip is the same on a 4DR. I am assuming that the rockers would be the same. Thanks for any info.

Restoring a 1960 Plymouth and like to read the advice from members. Location: Nebraska