Sir Dodge alot's latest activity
-
Sir Dodge alot replied to the thread Sputter and cut off.Hope I'm not putting something of "advice" that might not be necessary. When "warm" so not hot and up to operating temperature? I see... -
Sir Dodge alot replied to the thread General A727 Potential R&R questions/suggestions..Question if anybody is able to answer: The Flexplate has 4 bolt holes to the torque converter, but what is the small hole between the...
-
-
@Sir Dodge alot might be looking for one.
-
Sir Dodge alot reacted to 70bigblockdodge's post in the thread New Torque converter, rear gear change? with .100% agree with this. I put 1900+ miles on my Charger last year's power tour in a week. 3.23 with 15" wheels and OD trans 2600rpm is...
-
Sir Dodge alot reacted to 70bigblockdodge's post in the thread New Torque converter, rear gear change? with .I would go with what @CBODY67 said about raising your timing to help stoplight to stoplight. Timing is lazy on most of these cars. The...
-
Sir Dodge alot replied to the thread New Torque converter, rear gear change?.The timing is one of the first things I bumped up, around 14 to 15 BTDC, (I think I experimented with at least 25 BTDC but you can go...
-
Sir Dodge alot reacted to 69CoronetRT's post in the thread New Torque converter, rear gear change? with .The nominal difference between 2.76 and 2.94s will not be felt enough to justify the time and money spent to make the conversion. Make...
-
Sir Dodge alot replied to the thread New Torque converter, rear gear change?.Appreciate the feedback, & write up. Very good points you mentioned. I'll put the 2.76 replacement on the shelf for now.
-
Sir Dodge alot replied to the thread New Torque converter, rear gear change?.Yes this is my daily driver, I drive to college back and forth (16 miles or so) but due to some transmission issues, I'm currently...
-
Sir Dodge alot reacted to CBODY67's post in the thread New Torque converter, rear gear change? with .Thing is "gutless" has different meanings to different people. To me, the 2.76s are fine for city driving, especially after I added two...
-
Sir Dodge alot reacted to Big_John's post in the thread General A727 Potential R&R questions/suggestions. with .That's correct and why I said to check the bolt circle on your old convertor. It's possible that it's the same bolt pattern, but I...
-
Sir Dodge alot replied to the thread New Torque converter, rear gear change?.Appreciate the calculations, that's handy to know. I just figured the stop and go traffic is what makes the car gutless with the 2.76...
-
Sir Dodge alot reacted to 67_300_Convertible's post in the thread New Torque converter, rear gear change? with .If I'm doing the math right, you are looking at 6.5% higher RPM with 2.94's vs. 2.76's for a given vehicle speed. That would result in...
-
Sir Dodge alot replied to the thread General A727 Potential R&R questions/suggestions..Ok so I just did some research on the flexplates, if the New and the old Torque converter bolt circles are the same, I should be able to...
-
Sir Dodge alot replied to the thread General A727 Potential R&R questions/suggestions..Just measured the New Torque converter with two measuring methods. From bolt to across bolt center is 10 inches. The other method is...
-
