Recent content by TaffetaMocha

After replacement some cranking it started and got out of the cold weather, thanks!

Thanks, will update after trying replacement

After some winter driving, I went to start it in the morning and I had a no start situation, where I would hear it fire exactly once after I shut the engine off. Checked Ignition coil wire from distributor for spark on some metal, did not see any. Also tested the Ignition module and the Coil...

1973 Fury III with vacuum issues. The car surges at idle and will have popping when cold starting and occasional misfires while driving. Cold starting is also an issue. I decided that I should simplify and delete what I can. What are the essential lines I need? And also how do I use a vacuum...

Thank you, was able to remove

People in another forum told me to replace some electrical components in my radio, how do I remove it? Cannot find any information on repair manuals

unfortunately turn signals work and the fuse is good. Antenna connection is good aswell

Was using the radio, and all was well until it cut out. No sound, No static. Listened closely and I could barely hear a station while running at full volume. Tried to locate fuse, but it is not on my wiring diagrams. Can anyone tell me what fuse I should replace? or maybe another solution?

Good to know, thanks. Just ordered the TRW one and yes I have the single piston disc brakes up front

Sent to a mechanic after violent shaking up and down, could not find part after 3 weeks of looking and the one they did get was far too short. Where can I find a front right lower ball joint?

-Have replaced fuel pump after sitting for 10 years, old fuel pump was not working and the new one seems to not work well either. -Tested Flow from both a gas can and the tank, same low trickle -Replaced Fuel filter How do I know if my eccentric is bad or the fuel pump is bad? Maybe something...

Hey this worked perfectly, thank you. Windshield is in place.

This is a long shot, but what's a cheap way to bend this back into shape? I have the replacement windshield ready to go.

Float is good and buoyant, I did not check the needle movement. So I guess I should open the top and see

1. It was having the same issue before I rebuilt it, although I discovered the needle had fallen out of place before I rebuilt it. The needle looks fine from the inlet this time, but the same issue persists. 2. Yes, Everything was pretty much new-looking on the inside when I opened it up, apart...