Recent content by tinnman75

Thanks for the reply, The car sat for a long time when I got it out of the barn and never checked the seat, I just went into the restoration of it. Yes, all grounds are good and clean. I am going to pull the motors tonight.

I am putting my interior back in on my 1969 New Yorker and while I have the bench seat out, I wanted to lube and test all the movements. I have a good battery powering the red and black connector, under the seat, to the seat switch, but I get no movement at all thru any of the switch commands...

Thanks, I see the motors are electric after doing some research.

I am in the process of restoring a 69 new Yorker, 2 door and was playing around with the idea of putting a 300 grill on it? Is it a fairly easy swap if I chose do go that route? Is it just the grill, brackets and surrounds? I have not been up close on a 300 grill assembly to see how the...

Does anyone know if the plastic seat belt covers for a 1970 newport are reproduced? If not, Does anyone have some gold ones or the whole belt?

I am looking for 1, plastic, seat belt cover for a 1970 Newport. Gold

Do you have a photo or know what the side stripe would have looked like?

Here is what I have coming out of my firewall if someone can help. 1) 1/8"hose with a green stripe and 2) 1/16" hoses one with a white stripe and one with a green. I have no idea what goes where. Thanks

Well, a buddy of mine stopped by with a pair of 69 H.P. manifolds. out of a wagon. The pass. side fit like it should on the exhaust flange with my new exhaust kit. The drivers not so much. it appears it's up about an inch higher and slightly different angle. Does anyone know what 'C" body used...

Thank you for the reply... Here is what i have. I attached a picture of my original 'Y" pipe flange and manifolds

I have a 1969 new yorker with original exhaust manifolds 2562464 on the right side and 2463107. everything i lookup says those part numbers should be a 2 1/4 outlet, I bought a new stock exhaust system and it is 2 1/4 flanges. The problem is my exhaust manifolds I have are a 2" discharge...

I have a 1969 new yorker with original exhaust manifolds 2562464 on the right side and 2463107. everything i lookup says those part numbers should be a 2 1/4 outlet, I bought a new stock exhaust system and it is 2 1/4 flanges. The problem is my exhaust manifolds I have are a 2" discharge...

Anyone use this pre-made exhaust kit on ebay? Looking at it for my 69 new yorker 2 door. Thanks 1969 CHRYSLER NEWPORT DUAL EXHAUST SYSTEM, 440 ENGINES, ALUMINIZED | eBay

Thank you for the quick response. I don't have that diagram in my 72 chrysler book. Now I need to find the correct style heat valve as mine was missing.

Manual factory air, thanks