Rotisserie Restored 1966 Dodge Monaco 2 DR H/T Big Block Stroker Engine Torque monster - 574 Ft Lbs at the rear wheels!
Front to back and top to bottom this car has been completed rebuilt with only the best quality NOS, original restored, reproduction and aftermarket parts. Frame off body and...
1966 Monaco Tail light lens "Tuning forks" - Custom water jet cut and then chrome plated - I made several sets and have these left - I used super strong 3M VHB Clear tape to mount them as unlike the original pot metal ones these don't have locating studs - You can get the tape the exact width...
Good driver quality 66 Monaco Tail light lenses with re-plated "Tuning forks". Lenses are in 6+ shape - see pictures. They could be polished better or clear coated . The "tuning forks" were re-plated and glued on and would need to be glued again in some places (or use clear 3M VHB tape like...
Fury Pursuit - Here is a better picture of the Radio/Clock delete plate. I searched for a long time to come up with a factory setup as it was a key part to my "Less is more" theme of the car. The radio portion is molded in from the mfg, but the clock delete is a plate that is fastened from the...
Here's some more pictures of the resto - Some little tricks I did was the lower column support bearing is fabbed from stainless instead of the brittle plastic, upgraded to Borgeson style u-joints when I converted from Power to Manual steering and for the front seat trim pieces and rear taillight...
Thanks for the positive comments-
Ross - The rear seat bottom had fitment issues where the material for the driveshaft tunnel sits - the cover that Legendary sent was too short (height wise) - luckily we had NOS seat material and the upholsterer was able to stitch a longer piece in place of...
After owning this car for 17 years I've finally had the resources to do a completed restoration on the Monaco (my first car).
Rotisserie sub-frame off resto with some minor body mods to delete the exterior body trim and emblems with a 508 ci Muscle Motors stroker, upgraded 727 transmission and...
My 66 Monaco Restoration is completed, but I'm trying to find either a NOS or Minty set of rear tailight lenses - The Outers are available out there NOS on EBAY, but the inners are proving difficult.
A set of the now non-available reproduction sets from Down Under would be the second option.
I...
In the end I used all of the above suggestions and I think the grille and surrounds turned out pretty good. Start to finish to do all 5 grille/headlight pieces took me 50 hours. The key was the 1/8" 3M Fineline blue plastic making tape as suggested above to mask off the grille tooth chrome and...