Search results for query: *

Does anyone know where I can purchase the small plastic two part trim clip for the side trim on a 1967 Imperial? It requires about 25 per side. M Park has some, but not enough. Over time they get brittle and break. Is there another type of clip more readily available today that will work...

I replaced my very rusty original trunk deck lid with one in much better shape. After getting it painted and installed, I find that it will not stay in the raised position by itself like my old one did. The torsion bar is in the middle hole on both sides, which is the same position it was in...

Is the metal strip under the hood that the hood latch is bolted to and large spring, painted the same color as the car? Thanks!

I need to have the carrier bearing repaired on my 1963 Imperial. For removal, do I start at the rear end and remove that universal joint first? Then remove the carrier bearing? Will the whole unit pull out of the transmission at that point? I probably should replace all three universal...

1963 Imperial: There is one vacuum hose that comes through the middle of the firewall and goes over the steering column. Where does it hook to? There is a short vacuum hose by the emergency brake mechanism. Both ends of the short hose are disconnected. I could not find any information in...

Had the gauges in the cluster tested and calibrated. Now the oil pressure and temperature gauges (after warmed up) read correctly on start up and then slowly go back to home position within 20 seconds after start up. The fuel gauge does not work at all. Fuel sending unit in tank tested ok on...

1965 Imperial 413: Can one remove the right side valve cover without taking the heater box off from the fire wall?

1965 Imperial: Where do I find a small enough phillips screw driver to remove the inside door handle? The screw is on the end of the handle next to the door panel, providing very little room for a tool. Thanks!