Search results for query: *

The engine was running poorly, and worse with the a/c running, so it was disconnected. It turns out the problem was a vacuum leak due to a bad power brake booster (which was replaced with a new one). I just haven't had time to reconnect it. The condenser and compressor are still on the car, and...

For sale is my Chrysler 300, with 440 CID engine, 727 torqueflite automatic transmission. Car runs and drives. Engine has custom cam, Edelbrock aluminum intake manifold, power adjustable seats, custom side exhaust. Recently replaced power brake booster, re-did ignition points, and added 650 cfm...

Hi everyone, its good to be back on the site (I could not access it for over a month, did it shut down?). Anyways, I am about to put all the chrome on the 300 (1969), but I don't know which screw goes for the rocker panels. I can't seem to find them anywhere. Does anyone know what size they are...

I just saw it, and it was excellent.

The clips look a lot like the door panel clips, but the base has a curve so it can fit in the slot of the trim. I can't find them anywhere.

I purchaswed the car in Phoenix, Az, and yes it was green and black. The interior is red. I like the blackout look, but the trim holes are in the fender/ doors, and I dont want water getting in there.

Hi everyone, its been a while. I finally got the 300 painted (nothing fancy, it's just my driver). Now I need to put the chome on the fenders and doors, but I don't have enough clips (40 holes total) Does anyone know where I can find the clips?

Ok, so I think it is a power antenna, the bezel is small and has no notches. I hit the toggles above the radio, and nothing happened. Does it need to be in accessory mode, or is it just disconnected somewhere?

Hi everyone, I noticed my radio is still working, but is very faint, and I cannot see the antenna mast. How can I tell if it is the power antenna? Does anyone know where the switch would be? If it isnt a power antenna, does anyone know where I would find a replacement mast? Thanks

I have 4 300 wheel covers that I cannot figure out how to get on. I don't want to force it and scratch up my rims. Is there a special way to get them on?

Pics! Pics! Pics!

Ok, I ordered a champion aluminum 3 row radiator (should get it tomorrow). Should I flush ther cooling system (block) before installing the new one?

Does anyone know the stock radiator size? I'm looking at Champion radiators on Ebay, but the dimensions look too big...

Yes, the engine boiled over after I had the A/C condenser installed.

Hello everyone, I replaced the water outlet, as well as the thermostat. Since the coolant level dropped, I could see the cores of the radiator better. It looks like they are clogged with little white spheres, and about 50% of the opening is clogged on each core. Should I have it flushed...

Wow, that's a beautiful repair.

Thank you.

Okay, so I took the hose off of the thermostat housing, and it spewed a good amount of coolant (engine was cool). The Thermostat housing looks kind of corroded, and It doesnt seem like there is a gasket on it. This definitely should have a gasket, right?

To answer everyones questions, yes it has a shroud. The car has been running a little hot, but nothing like this. I noticed when the engine was boiling, some coolant was bubbling from the rad cap, so I will replace it and the thermostat, and check the radiator.

Which thermostat should I run in hot weather? it currently has a 195.