Search results for query: *

  1. Frank Odenthal

    TF 727 Output shaft end clearance in the case need to be adusted/ shimmed?

    Hello transmission Pro‘s, Just putting together my 66 A727 transmission. I’ve put in 3 new thrust washers in the Output shaft Assembly and measured clearance under the small Snape Ring on the shaft within tolerance (.016“ /0.4 mm). Installed the output shaft assembly back into the case and...
  2. Frank Odenthal

    1966 AT 727 repair - questions

    My 1966 AT 727 with a 19-spline is being overhauled. While inspecting my front clutch with four friction plates, I noticed that an additional metal plate was installed in the base of the mount. The measured clearance was 0.055" (1.4mm). When I remove the too much metal plate, the clearance is...
  3. Frank Odenthal

    66 A727 torque converter 19 spline.

    just Dropped the AT for rebuild and found this hugh red 12“ Converter with 11“ bolt circle. It is stamped with a number R090. Does anyone know the Stall speed specification ? Shaking the converter makes a rattle noise. Is that normal. It rans without any noise when Parked. Can not find any...
  4. Frank Odenthal

    440 source bushed stainless Rocker Arms.

    I‘m interested in the new 440source bushed stainless Rocker arms when rebuilding my engine with 440 source heads. Has anyone made first experience or high milage on them ? Thank you, Frank.
Back
Top