Search results for query: *

  1. Rubatoguy

    Looking for two-pronged temp sensor for '71 Chrysler and alternate location.

    My '71 300 had an aftermarket gauge kit put in using the original temperature sensor hole. The wires for the original sensor were left unconnected. I would like to bring them back to functionality, because I want the gauge and the lights! Does anyone know the part number for the correct sensor...
  2. Rubatoguy

    Testing lighted ignition switch - 71 Chrysler 300

    '71 Chrysler with the A01 LIGHT GROUP - this says it includes a time delay ignition switch light. Mine is not working. I am guessing the first step is to test the bulb under the cap, but if that does not work, what would you check next? I am guessing there must be a relay somewhere. thanks, Todd
  3. Rubatoguy

    Trying to identify which bulkhead connector my car uses. '71 Chrysler 300

    I found the bulkhead connector in my '71 Chrysler 300. I'm surprised there have not been issues with shorts from water dripping. (Had that problem with an old '93 BMW 325 where the ECU was placed right under the hood drain.) Does anyone have any tips for cleaning the connector and connections...
  4. Rubatoguy

    Need help identifying loose gray wire in engine compartment near the voltage regular

    I was looking in the engine compartment of my 1971 Chrysler 300 and noticed a loose gray wire by the voltage regulator. It appears to go into the wrapped wiring. Does anyone know what this wire is for and where it should go? thank you, Todd
  5. Rubatoguy

    Ammeter question

    I understand that at some point the wiring of the ammeter gauge was made with an external shunt. Somewhere around '73-'75 on. Does anyone know where to find (or have) one of these? Or a part number? thank you, Todd
Back
Top