Shorty65
New Member
Been going through all the electrical on the car and now I’m on the windows. Any tips or tricks taking them apart or cleaning the motors or regulators so I don’t end up replacing a motor that was only seized from grime
Where did you get the new motors from? And was it a major pain? But sadly no I don’t have any spare parts just all original lolJust got done with that. Replaced all the motors. Only issue left is I broke the upper front taller on the driver side quarter window and the plug in for the switch on the passenger side fell apart so I’m looking for a replacement. I cleaned the rails and used high temp wheel bearing grease.
You wouldn’t have a spare single switch with wiring laying around?
Where did you get the new motors from? And was it a major pain? But sadly no I don’t have any spare parts just all original lol
Hey dart4forte do you know what your part number was? Can’t seem to find them.
Awesome thanks
Funny you should say, waiting on the walk in clinic to open nowBe VERY careful taking the motor off of the regulator, unless you like getting stitches. The spring on the regulator is strong enough to hurt you.
Just good penetrating oil on the regulators and mechanism. The contacts on the master switch and door switches can get dirty and such. The "buttons" should all have the same feel and readily return to the center of their travel when released, but some might have lost their "spring", so to speak, and might need "help" or replacement.
You might also check the resistance and voltage at each of the connectors at each of the motors, for good measure. The rh rr power window on my '70 Monaco always worked slower and weaker than the other ones. Never did figure that one out! Probably the least-used one and it worked like it was worn out. Even needing some manual help in pulling the glass up WITH the button pushed!
I recall the local service manager talking about what a pain it was to work on power windows. That the spring on the regulator was quite strong, too, which was a caution of its own. If there's not a guide hole you can put a small bolt through to keep things together, it might be good to drill one. Just be careful!
Perhaps some penetrating lube will get things freed-up well enough so that anything more involved is not necessary!
CBODY67
Ouch! I hope it didn't get you too good. I didn't know that either the first time I popped a motor off of a regulator. I just got lucky and used a screwdriver to pry it off, and didn't have my fingers or hand in there.Great advice about the spring and securing it before the motor is removed. Wish I would have read this yesterday. Any advice on how to retract the spring to get the motor back bolted in place?
With one hand or two?Great advice about the spring and securing it before the motor is removed. Wish I would have read this yesterday. Any advice on how to retract the spring to get the motor back bolted in place?