1972 Town and Country -floor pan wuestion

[mopars4life]

I know flor pans are hard to come by and I’ve heard these aren’t the greatest fit. I was wondering if the contours are the same for a 72 model since these say 65-70 only. Thanks for any help! I need a big section for pass front and small for drivers front.
https://www.c2cfabrication.com/prod...ab4acpmi44rTyJ-HTYwKoWtSRh3hTeiwaAmIeEALw_wcB

 

[bigmoparjeff]

The c2c panels are generally considered to be slightly better than nothing at all. If you don't want to invest in a bead roller and you're not building a show car, they will get the job done.

The panels they make are just an approximation of the original, so it will be about as close in a '72 as it would be in a '65-'70. The basic dimensions of the front floors are pretty much the same from '65 to '73. Some '70's and all '71's had some minor changes made to accommodate the rear mounts for the isolated sub frame.


Jeff

 

[71Polara383]

What Jeff said. They will work. I used some on a members car. They came out. OK I guess.

 

[mopars4life]

Thanks for the advice. Will see if I can get them then and give them a try.

 

[Big_John]

Thanks for the advice. Will see if I can get them then and give them a try.

My experience with c2c junk was horrible. IMHO, their stuff looks like something built in high school shop.

@bigmoparjeff 's "slightly better than nothing at all" is accurate, possibly even a little generous.

 

[mopars4life]

Yeah it’s too bad AMD or another reputable manufacturer isn’t re-popping these. Clean originals are hard to come by…. I found a new one near me someone has for cheap so that is why I am considering.