Colin_300
New Member
I have a 6v-71 supercharger that I’m rebuilding for my car. Now that I’m done cleaning it, I’m going back to rebuild it. I’m to the point of replacing the rotor shaft seals and on mine and they don’t fit at all. I did order the correct seals/rebuild kit to the best of my knowledge. My rotor shafts have this ring type seal. I’ve now been researching for over 3 hours and I can’t find anything at all on this. Everyone else’s rotor shafts don’t have this and I haven’t seen a single image with these rings. I’m completely lost on what to do. I was wondering if you guys have any idea what’s going on here