77newyorker440
Well-Known Member
Good Morning Everyone,
I have a few questions about my wiper system. Following your recommendations, I pulled the entire system and replaced all the bushings (I've actually done it twice now and am able to do the whole system(from removal to reinstallation) in about an hour, quite proud of that). I used the Dorman 49440 bushings as recommended. However, my problems continue. When I turn on the wiper system, the wiper arms slam down into the plastic stops, and then go into motion, going lower when turned on than where they are in park. Why would they do this, and what is the fix?
Thanks,
77newyorker440
I have a few questions about my wiper system. Following your recommendations, I pulled the entire system and replaced all the bushings (I've actually done it twice now and am able to do the whole system(from removal to reinstallation) in about an hour, quite proud of that). I used the Dorman 49440 bushings as recommended. However, my problems continue. When I turn on the wiper system, the wiper arms slam down into the plastic stops, and then go into motion, going lower when turned on than where they are in park. Why would they do this, and what is the fix?
Thanks,
77newyorker440