Recent content by 74delta

Brand new in box. Sold car before I got the chance to install it. $175 plus shipping and any PayPal fees

383/400 single plane intake $75 ships on your dime

I have a brand new only opened to look at holey sniper efi master kit part # 550-511k that is going for $1400 on summit for sale for $1200 shipped. I also have brand new holley sniper distributor for 383/440 part # 565-305 $277 on summit for $200 shipped. Also have the sniper ignition box part #...

Located in Massachusetts, 02188. Thinking of selling my 1965 chrysler 300 4 door hard top. It is a 383 big block car with a 727 auto on the column. Great running and driving car. I have added an edelbrock carb with electric choke and a sure grip center section. Everything works minus the ac. It...

I could use a couole things. The passenger rear skirt trim, lower rear windscreen trim,

Preferably looking for a single plane to compliment my holley sniper but would do dual plane if the price is right.

You put that part number on a 67 300?

Honestly haven't put much thought into exact cam specs yet just something to take advantage of 4 decades worth of newer cam tech. I'm not someone chasing the chop chop sound.

Sniper is the holley efi kit. I've read it like single plane intakes more than dual for tuning purposes.

Well I have a sniper effect kit ready to go on and was planning on a single plane intake and a small cam. The previous owner did a homemade dual exhaust but the pipes from the manifolds to the under car were done very poorly and are definitely a bad choke point. So I was thinking some shorty...

Does anyone know of any shorty headers or even long tunes besides tti that fit a 65 300 without having to modify too much? Want to re do my exhaust but just can't justify the price of the tti yet the car still needs more before id drop that kind of coin.

I haven't cleaned it up but again came out of my running driving and on the road 65 300.

Debating on unloading my extra 742 case. It is open aka non sure grip with 3.23 gears. Came out of my running driving 65 chrysler 300 only taken out to put a 489 case with suregrip. Not really sure what the market is for them but anything less than $300 id probably just keep it around as a spare.

So wound up bringing the center section to a shop. Turned out the crush sleeve wasn't nearly crushed enough. Replaced the pinion bearing out of an abundance of caution since I did put a few miles on it. All is good now. No strange noises or chirping and the cone style sure grip worked very well...

Not sure about the cones but I can say all the bearing that could be seen for sure were new seals aswell. Even the messed up pinion side had a brand new seal.