Separate names with a comma.
Thanks for the advice guys. I figured a one off might be the only way but will probably be cost prohibitive in this build at this time anyway....
Hey Guys havent posted in a good long while but lots going on with the car so thats whats its really all about, right? anyways, does anyone know...
hey all thanks for the replies. as 413 mentioned, the 65 and 66 consoles are quite different - both pretty fricken cool in their own right, but...
Hi All I have a 1965 Dodge Monaco - stock drivetrain was 383/727 I am replacing the engine with a 440 (stroked to a 522) expecting roughly...
its an original Holley that has been reworked - Ive always run Carters and then Edelbrocks but I do have buddies that have great success with...
FYI - while it could be modified to work - the two brackets are different. Since Ill likely go back to an Edelbrock at some point Im not going to...
mechanical fuel pump - don't have a pressure gauge in line, but tested when installed and was 3.5-5 lbs. Thanks for the tip on gasket - I...
1407 - manual choke - not hooked up. plan to run a 650 vacuum secondary - no choke long story is i bought the 1407 and installed it with a weiand...
well dat'd be convenient....for once! haha thanks Commando!
Guys, Its a rather long story but Im wanting to swap carbs for a few reasons this evening after work - I have a 650 Holley that's been previously...
I was able to verify with ECI so I figured to post for information According to them, the Chrysler OE dual master cylinder that they provide in...
im about done with my ECI installation but the M/C fittings are giving me a problem - Im using the dual they supply in the kit. The Front fitting...