Recent content by doooodaaaah

I wonder whether yours have been apart in the past as your pistons dont have a tail on them to help them stop tipping in the cylinder?

To be totally honest I’ve only done a few hundred miles in it had a couple of problems with tcu programming (sorted now) and then was waiting for some adjustable dampers to be made for it and now waiting for a pair of new rear leaf springs to be made But they work fine and there no signs of any...

I Picked up the seals and fitted them,bled the system ran the car up and applied the brakes really hard dozens of times and no leaks from the pistons so fingers crossed I've cured the leak need to road test it for a while to make sure their ok when theres some heat going through them. one slight...

I took the leaking caliper apart and one half had the black piston in with a different kind of seal I have a feeling as it has no tail it may have caught on a bit of corrosion on the cylinder wall (it’s stood for a year while I was fitting the SRT8 motor)and flipped slightly and stuck and let...

Thanks for the offer i'll keep them in mind

they dont ship to uk

Ive Just contacted them a the website say they dont ship to my location (uk) my issues are by the time they've got here with duties they'll most probably be close to $1300 also going to need rotors sooner than later so new pads to i haven't even looked into those properly yet im guessing...

Thanks, I'll contact them see if they ship to the UK trouble is if i have to return them chances of getting my import duties back are slim

just looked on rock auto says the the lincoln's bolt circles 4.25 not 4.5 am i missing something?

I’ve just started taking mine apart I have to kinds of piston in one caliper I suspect it’s incorrect

it had crossed my mind to do this but i thought refurbing or replacing the calipers would be eaiser, but being my first mopar i didn't realise the brakes were that rare or hard to get parts for. Can I ask which wildwood calipers and what rotors you used? also you have any photos just to give...

Does any body have a lead on replacement budd caliper's or rebuild kit or even an aftermarket caliper that can be made to fit? Ive Got one that's leaking Im in the UK which makes it more difficult Thanks In advance

Thanks Jeff saw some on an old eBay listing no retainers on them I’ve peened the end of the bar slightly I’ll see how it holds up I really appreciate your help thanks again

Thanks Jeff

Thanks Jeff I had wondered if it might be those I took the other side off to look but there’s nothing holding the rollers on that side either other than the torsion bar end had been slightly peened over the rollers won’t come of that side,i can’t see that been the factory solution‍?