Recent content by Fury Rookie

Hi Everyone The motor in my fury took a big healthy crap. Got a motor that was rebuilt years ago but never Installed. It is a LA 360 but has magnum heads. Block is 1975 and the heads are 2006 to I think 2014.. it has an intake that is a few inches taller then the old performer intake that...

I bought today a can of Chrysler green. I can't see me to find much on it. I would kinda like a greenish turquoise color. Is this even close? I tried Chrysler turquoise but seems too blue to me . But then again I am color blind. Thisis going on engine . Any help is greatly...

Anyone know if this is LA block or magnum. Thanx Frank

Hi guys How do you tell if the heads on a 360are the correct ones. Magnum or LA heads. I have a performer edelbrock intake ut seems to leave a large gap when sitting on top of block. Pics are posted

Thank you Big John

Hi Everyone Anyone know the ohms on a 68 Fury fuel tank? Also is the any good source to get it? Thanks Frank

The fuel gauge in my 68 fury is usually on E but sometimes around corners will jump to 1/4 or more and slowly goes back to E. What do you guys think is haywire. Thanx Frank

8695s is the seal used on axle. Do u know the inner dimension by any chance That would be the dimension of the speedie sleeve

Would they be same as forv68

I was on dr diff site and it shows axles for a body and b body and e body. It also lists custom axles including same length and length for drivers side being 3/8 inch longer. Are any of these for 68 Plymouth Fury 3? As always any help is greatly appreciated Thanx Frank

Hi Everyone I need the dimensions of axle size for my 68 Fury. I need to find speedie sleeve as my driver side axle has a very small divet in it and is causing axle sleeve to leak Any help greatly appreciated Thanks Frank

Got it from summit I have 3 now all doing the same

Thank you fury got. I am having big issues with this . The little metal nut does not stay in place no matter what you do. I tried the grease on the prongs and that did not help either

Just replacing the orange ignition box. When I go to put wiring harness on 4 prongs they don’t go on all the way and screw does not get tight Any help greatly appreciated. Frank

Just replacing the orange ignition box. When I go to put wiring harness on 4 prongs they don’t go on all the way and screw does not get tight Any help greatly appreciated. Frank