Recent content by Mike Browne

  1. M

    Alternator

    Using new electronic reg. I have two dark blue 12 volt ignition wires and one of the dark green field wires from the alt to the red wire on the electronic reg. And the other field wire going to the other black wire on the electronic reg. Is this correct. Two hot wires and a field to the red...
  2. M

    Alternator

    I have install a two field alt on a 68 300. Which field go's to the pos side of the new regulator. Or it my not matter.
  3. M

    alt upgrade 1968 to 1970 two field

    Thank you. nice place to live. never to hot or cold. and no rusting car.
  4. M

    alt upgrade 1968 to 1970 two field

    Picked up a two field alt and regulator. The new alt has a smaller pully 2 1/2" OD old alt and not sure if it had the correct pulley was 3 1/4" OD. This will spin the new alt faster. Is this OK? This is for my 1968 300 with A/C. Lost alt on the way back form car show Saturday. Cut belts off and...
  5. M

    need power antenna information 68 300

    not looking good. At this time I have to remove the antenna for my cover and I was told it is not a good one for reception. I would move it to the back but the paint is to nice to fill the hole. It looks like I have room to work to replace it with out removing the fender. I will look for an...
  6. M

    need power antenna information 68 300

    Looking to find and replace the antenna on my 68 300 with a power one. It looks like a tight fit. Did this year have the antenna that did not go all the way down? Is there an after market one or can I find one used and rebuild it. any one do this.
  7. M

    How to remove and replace back seat 68 300

    Was thinking about using the grey and replacing the padded part of the door panel above the arm rest. I bought an extra yard of grey to do this.
  8. M

    How to remove and replace back seat 68 300

    The grey is darker than photo shows.
  9. M

    How to remove and replace back seat 68 300

    This is the black and grey that Legendary recommended. I think all black is correct but I went with b/g. what do you think. Its ok if you do not like it.
  10. M

    How to remove and replace back seat 68 300

    Picture I hope
  11. M

    How to remove and replace back seat 68 300

    Was just looking at the post about converting mikes 66 rear seat. much bigger job then my 68 300. I did see something I my be missing. Did the 68 also use a filler on each side of the seat back 0n the 68. It looks like I my be missing a filler. My seat back fits from side to side but near the...
  12. M

    How to remove and replace back seat 68 300

    I got it. It was a fight. Thanks for the tip. The first time I tried. The speaker grill has screw holes along the front and thought I needed to screw It down first.
  13. M

    How to remove and replace back seat 68 300

    Thanks I will give it a try after work today.
  14. M

    How to remove and replace back seat 68 300

    It is. But it must go through the center bracket holes before going over the seat. I will give it a try.
  15. M

    How to remove and replace back seat 68 300

    It looks like the emblem needs to hook in the center holes and then go over the seat top and bold from inside the trunk?
Back
Top