Recent content by Pops62

What a honor and tribute I can’t wait to see the car in its glory Thank you for sharing

[email protected] I keep getting an error message when I try to start a conversation

Thanks I am not good at this I have tried to pm a couple times and I get error message for the

Of you would be able to private message me I have a few questions for you thanks for your time and help

Thanks for the info Yes the car had a 361 originally I want to keep the push button setup I want to go to disc up front when I can I will check the rear brakes it’s apart. And I can’t get close to it yet I lost the lower part of my left leg late last year so for now I’m a little limited I am...

Pictures of my car or the motor? Please message me so we don’t mix things up on this thread

I am going to install a1968 440 into my 1062 dodge 880 and want to keep the pusbutton transmission I am also going to install a challenger reared Why you ask? The 440 is rebuilt and it’s running on a stand (The motor in the car is not original) The rear is a 489 poi’s and I have it I am...

Your post was about a friend picking up a 58 300 and went into minimal work to get it going I was just offering something to help the cause. I should have known better!!!!!!!

I have a 58 350 ready to come out of my 62 dodge most of the work is done The guy I bought the car from said it was rebuilt when I took the valve covers off it was spotless inside not grime or sludge I have everything here to take it out (the trans has to be unbolted from the engine as I need...

Thanks Sgt.Fury It’s not rust free but it’s pretty good start . There’s one for sale in Carlisle pa but he won’t ship I’ve been reading a bunch of your stuff I figured you would be some one that would have the answers Thank you so much

Thanks guys I’ll have see if I can get some measurements and match them up to my car I figure if length and width is the same and then hinges are in same location Then see if latch and lock location match I will take the risk and buy it

Thanks Ross I really think it would fit just not sure of demensions I happen to like the dodge letters in back even though the hood I am considering doesn’t have them I have read through the thread by furious a couple times and it says 61 Polara would fit then I read long vs short wheel base and...

Thanks but they are not close enough for me to do that thanks I just contacted someone on here for is help

i found a trunk lid that is in very good shape just trying to figure out if it would fit my 62 880 again it’s a 61 Seneca Thanks