Recent content by schwarzsurfer

Hi, seems like a combination of a broken pick up and a worn out distributor rotor + cap caused the problem. After replacing these parts the engine starts right up! Thanks for your support! Marian

Some years ago I did all the wiring new and the car drove well for 5 years now without any issue. So I assume it could not be a wrong connected wire. It just stopped producing sparks while cranking from one day to the other. Maybe my batterie is dead and the voltage drops that much during...

Hi all, I bring up this old thread because I have the same issue and did not find a solution yet. My 72 Newport with factory electronic ignition does not produce a spark while cranking, but it does, when the ignition switch is in Run position. I changed the coil, the pick up, the ballast...

oh did not know that. do not really like it to be honest. my aftermarket one went down all the way. maybe I will just try to get to orignal bezel and mount another aftermarket antenna..

I don't know the correct length. Maybe I can remove the inner fender so I can access the antenna and measure between the antenna hole in the fender and the mounting holes in the firewall..

Not yet, will ask him

Hello, the power antenna on my 72 Newport stopped working. Was not an original one as well. So now I want to restore it to the original status but I need a correct working power antenna for this project. I would also need the original mounting bezel. Maybe someone has one? Thank you Marian

Ok, I think I found the reason why this bottle does not fit my 72. It looks like the bottle goes to a different location in 73. In 72 there is the AC dryer at this place it goes in 73. I found these images of 73 in another thread. Marian

Hi, I try to figure out which overflow bottle is correct for my 72 Newport. I think the one you have is the correct one, even the picture in the manual looks the same. But I bought another overflow bottle and I think this is 73 one part number 3673836 which should be correct for 73 C-Body...

Hello, I'm looking for a driver's door window glass track with mounted up stop with the two matching rollers that attach to the window glass. I think the track should look like this: The rollers might look like this, I'm not sure 100%: Thank you Marian

Looking for a driver's door window glass track with mounted up stop with the two matching rollers that attach to the window glass. I think the track should look like this: The rollers might look like this, I'm not sure 100%: Thank you Marian

Looking for a driver's door window glass track with mounted up stop with the two matching rollers that attach to the window glass. I think the track should look like this: The rollers might look like this, I'm not sure 100%: Thank you Marian

Private message just wanted to let you know I sent one.

Hi, did you sell the car are would you put some parts out of it? Thx

PN