Recent content by Skihat

What I came up with was this.... with the understanding my rad is 063, think this shroud was for the 053 (B body?) 1624506 only avail from QQE as the #22 snubber bushing Sill not sure what 2099962 and 2099963 are..... "Filler - Fan Shroud to Core, w/Air Cond., Upper .Lower" this is from the...

Does anyone know if the small corner bushings on the shroud are still reproduced? Or how a seal is supposed to mount? Looks like it could use one but I can’t find an image of the part #

wait, are you trying to ID the rear bumper bracket to body bolt?

I ordered every option Mr Gs had available. Tried an eBay seller based on the OE number. In the end , I purchased a replated $300 “outtake” rear bumper. It had collision quality prep / imperfections before replating and had sat for a while in a shop. It came with slightly oversized bolt...

Hey All, Anyone have a part # on this? Maybe I'm not seeing this correctly..but a direct replacement doesn't seem clear. (for the linkage arm that attaches to the passenger side pivot) When I look at the parts manual, forums, and suppliers it seems like you may have to source an indirect...

Sent you a PM!

Excellent! Much appreciated

Looking for a good Right passenger front fender trim for a 1968 Chrysler 300. This is on the fender/body at the grille opening. Previous owner actually broke mine. As you can see on my opposite side shown, after polish... the tarnish and finish condition (especially at the top) is driver...

Good stuff here & lots of leads, thanks all. Anyone ever used this product line?

Thanks, Going to have to check with them. Almost wonder if what they offer would be the same black vinyl on the door panels. Do you happen to know if the upper dash pad itself can be separated from the dash frame in the car? I always thought it had to be removed entirely, but I was just...

Interesting to hear this, hey,have you ever identified a decent supplier match on vinyl or the correct foam / density? I’m going to get set up to start taking care of this when the weather breaks

Yeah, that's where I landed on this until further notice. He said he installed the dash pad....but it appears almost like a pre made slip cover that could be installed without removing the panel/pulling the shield. Came out nice regardless

Hey all, Is this upper dash pad a cover sold by a vendor? I recently saw these photos on here of a sold car and contacted the member. They kindly responded they were not aware how it was recovered. I like the accent of the stitching around the end curves, anyone seen this type of a cover...

Looking for a clean / straight rear bumper for a 1968 Chrysler 300. Thanks

I love big cars Location: New Hampshire