Search results for query: *

On my 1964 Chrysler 300, under the hood is an assist light. You pull it up and out and unwind the cord. All of a sudden it came on and stays on. What is the trick to turn it off? There is some kind of switch above it but it is not connected to the light that I can tell. In the pic I have...

I have asked this before, but does anyone know how to lower the front split seats on a non-power seat on a 64 Chrysler 300 split seat? I have them out and trying to figure out how to lower them. They are set up for a petite lady, which I'm not. I have lowered them as much as I know how by the...

I have just bled the rear brakes on my 1963 Chrysler 300 and attempted the fronts. How do you get a wrench on the front bleeders, let alone the drain tube? The steering knuckle won’t let you get a bleeder valve box end wrench on either side. Is there a special bent open end wrench you use? Or a...

I'm hunting a stock air cleaner in good condition for a 1964 Chrysler 300, 383cuin, 4bbl Carter. I presume the 1963 - 1965 are the same but can't verify that. Anyone have one for sale? Top is a 1964, bottom is a 1963

My 1964 Chrysler 300 has an issue. When the lights are Off, the left rear brake & turn signal do not work. The right turn signal and break light work normally. When I turn On the lights, the left turn signal and brake light work ok. With the lights On, the right turn signal still works and so...

I see a lot of discussion about “open”or “closed” position but which is the “open” or flow through position? Is the counterweight horizontal or vertical in the open position? Thanks. Chuck

My 1964 Chrysler 300 convertible has little seat room. It is like it was built for a 5'4" lady. After getting new seat foam it is very tight, especially close to the steering wheel. I'm 6'2" and it is like I'm on top of the steering wheel, with little leg room. Is there a way to extend the seat...

Hello, I’m working on the 1964 Chrysler 300 “383”. I have drained the antifreeze, but can’t get more than about 2.5 gallons out, even running the engine for a few minutes. The Shop Service manual says it holds 16 quarts + 1 for heater. That would be 4.25 gallons. I have drained 2.5 gallons...

I have a 1964 Chrysler 300 Convertible with electric windows. I see some threads about 1965 and other years window motors. None will fit a 64. The issue is the Drivers side motor. The wheel inside the motor is broken. I have contacted Dorman and looked trough their website, but no replacement...

Hello, I recently purchased a 1964 Chrysler 300 convertible w/ 383 cuin and Pushbutton Auto from the estate of a Chrysler dealer mechanic who bought it new. (My first Chrysler, I normally have Chevys). It only has 74,000 miles. I’m trying to figure out what modifications he made. One was the...

My new to me 1964 Chrysler 300 convertible has a bad Power Brake Check valve. I have ordered about 6 different versions from different Flaps/ Amazon. None will fit the hole in my booster. Most are 1/2” or 5/8” or 3/4” grommets. My opening is 1 1/16” hole. I did find a Dorman 80189 that has 2...