Search results for query: *

If a 1970 Fury with a 318 came with a 727, would the 727 be a direct replacement for a 1970 Fury with a 383 that came with a 727? Thx.

I have good vacuum at the PCV valve and the valve rattles, but I don't get vacuum at the breather opening when I do the "paper card" test from the FSM manual. Is this something to be concerned about? Thx.

This was dangling from the wires going down to the starter. It was attached by fabric tape wrapped around that plastic clip to the left and around the starter wires. The fabric tape and the plastic clip look original. There is a small tab sticking out of the other side where the rectangular...

The FSM says to lower the front of the tank so the filler tube clears the hole in the rear crossmember. I don't see how that is going to work with the bracket that is clamped to the filler tube. Is the filler tube just stuck down through a grommet into the tank? I was thinking of trying to...

What should I set the high and low idle speeds to on a 1970 383 with an Edelbrock 1406 and an automatic transmission? This is the 4 barrel version of the 383. The manual has several idle speed specs, depending on what carb was on the car (i.e. 700/1700 and 750/1800). That made me think it was...

I got a 1970 Fury last week. We drove it onto and off the trailer but it otherwise has not been driven or run for many years. I tried to start it yesterday and was unable to. I've been looking at it and found that one vacuum port was open, the electric choke is not connected, and the choke is...