George.Kamarinos
New Member
Hi all, am after the offset measurement between the diff housing flange and the tapered splined axle flange on 1961 Chrysler C body Windsor, New Yorker, Newport, Saratoga & 300G.
I have been in touch with reps from Wilwood, Magnum force & the Chrysler 300 Club International however everyone is happy to give their input and criticism but so far no one is happy to pass on this info if they have it. So I'm know reaching out in this forum for help to assist me in making a decision on what set up to use as they are all asking for the offset measurements. I don't want to separate the drum from the axle hub before choosing the product.
My vehicle is a 1961 Chrysler 300G and I am located in Melbourne Australia. Its extremely difficult to source info and parts, so am hopeful this forum can help regards George.
I have been in touch with reps from Wilwood, Magnum force & the Chrysler 300 Club International however everyone is happy to give their input and criticism but so far no one is happy to pass on this info if they have it. So I'm know reaching out in this forum for help to assist me in making a decision on what set up to use as they are all asking for the offset measurements. I don't want to separate the drum from the axle hub before choosing the product.
My vehicle is a 1961 Chrysler 300G and I am located in Melbourne Australia. Its extremely difficult to source info and parts, so am hopeful this forum can help regards George.