robert.k
New Member
Any one used Year-OnePart Number: EX66LHRH reproduction trunk extension panels 1966-1967 B-body in a C-body
Trunk extension panels 1966-1967 C-body
- Thread starter robert.k
- Start date
robert.k
New Member
The Drain plug is in the same location and same shape (round with a flat bit) and the pressed lines look close. I only need the lower portion !
I was wondering about the profile near the wheel well opening ?
I was wondering about the profile near the wheel well opening ?
67Monaco
Go Woke, Go Broke.
It might could be close. But a little shrink here a little stretch there and you can make it fit.
greasemonkeyman
Well-Known Member
What part are you looking for and for what car?
67Monaco
Go Woke, Go Broke.
He's looking for a trunk extension for a Slab.
patrick66
Old Man with a Hat
Good luck finding a useable one. "B" does not equal "C" here. Yeah, they may look the same, but the quarter dimensions are not close! The location of the drain hole is irrelevant.
You'll be better off finding a good sheetmetal guy and have him fab one up for you, as I guarantee if you try to use that "B"-body part, you're going to have more work in that in trying to make that piece fit that hole, than if you simply have one made from scratch.
You'll be better off finding a good sheetmetal guy and have him fab one up for you, as I guarantee if you try to use that "B"-body part, you're going to have more work in that in trying to make that piece fit that hole, than if you simply have one made from scratch.
67Monaco
Go Woke, Go Broke.
Isn't that what I said?? 
commando1
Old Man with a Hat
patrick66
Old Man with a Hat
Wait, let's go back to post #2...wait, let's go back to post #9...WAIT!
Similar threads
