Recent content by Binky1945

Thank you for your prompt report Big John I had a much more knowledgable friend come over for a quick look see and he did find the problem to be with the way my son had reconnected the yellow wire which did result in everything under the hood going dead because of no power fed to them It was...

Hello, I am Jim Dent. I haven't been on here for quite some time but I find myself needing learned assistance on an ignition/starting issue on my 1973 Plymouth Fury. I cannot get the motor to start. It turns over just fine but the electrical connection that supplys the spark is not there...

Thank you, Jim I did so again and nothing suspicious , broken or loose found.

Thank you for your response. I have located a right side mechanism and it is just over two feet in length. It is correct but it does not have the black plastic finger pull handle. I have ordered a NOS assembly to either use or rob the handle off of. I cannot find a Mopar parts number for...

No I don't believe so, inboard lower beams are cut out out of the lighting circuit and are utilized as alternately flashing blue sealed beams. Outer high beams were working fine as primary driving lights and did dim when the floor dimmer switch was activated. Had the best of both worlds until...

1973 Plymouth Fury 2, 440, four door sedan. Looks like it takes a # SMP24529DG headlight wiring harness for a # Q628TY replacement headlight switch. Regardless of whether these numbers are correct to your files lets say that I do believe them to be correct for my purposes. I have looked high...

i need a good used (right) passenger side fresh air door vent cable handle ***'y. It is about 1.5' in length and actuates a metal air cone thingee used to bring fresh air into the cabin from the passenger side thru the heat/cold levers using a vacuum system. It is a simple plastic finger pull...

Thank you for your assistance. I am not computer literate by any means and every bit of assistance is appreciated.

I have had a dozen of these made up. It was factory placed on the dashboard of the 73 Fury 2 police car we are rebuilding. I don't know how many different years and models it was installed in. If you would like one please send $15.00 to my PayPal acct and send your mailing address to me at E...

log in

Thank you, no i'm just looking for the manual antenna. I have bought a ton of stuff from Murray. You are right, ill give him a call thank you for your reply jim

Hello, does anyone out there have a complete original fender radio antenna ***'y for a 73 Fury for sale at a good price? Would prefer a good used straight three section if available. Don't think I can afford a nos one but you can quote me. Thank you Jim Dent ([email protected] or 859...

No but I certainly will on Monday, thank you. Jim

Hello again, Does anyone have a mopar parts number for the cork gasket that embeds in the flat side of the heater core support frame? It is about 20" long by 10" wide and about 3/16" thick. I see images of it in the Mopar chassis blue book but I cannot find a parts number. Also looking for...