Hearz ah few thoughtz. The filler neck will not be much longer then 6" or 8" and held in place to the quarter panel by 3, 1/2" metal screwz. Under that will be a rubber donut that holds the filler neck into the fuel cell. remove the 3 screwz and pry on the 3 "wingz" to get the filler tube up from the donut JUST AH BIT. Now, If you do not have a spray can of Brake Clean go get one!!! Then with the hollow plastic tube attached squirt brake Clean around the inner edge of the donut where it touches the filler tube. Then twist and pull to remove the filler tube 'til it's out. (More then one application of Break Clean might be required to complete your task 'cuz the stuff evaporatez pretty quick). Now to the bottom for the 2 support straps. First, Jack up the whole car by the differential so you can get two jack standz under the frame rails in front of the wheels. Remove the left wheel after dropping the floor jack and then Impact the nutz off the J boilz if you can, but if you're forced to cut them borrow ah bolt cutterz. NO sawz-all or cut off wheelz here!!. J boltz are cheap. Remove the fuel line and the sending unit wire from the tank and drop the tank out. BTW, There might be a stone shield cover protecting the tank too. No big deal, It will be held in place with ah few metal screwz.... Piece-ah-cake, Jer