Search results for query: *

They will come out without taking the belt apart. Hot water soak or heat gun.

summons some creativity and make one from another seat belt.

You can get it wet again and put some flat weight on it to straighten it out. Remove all the clips first. And make sure it’s very dry before installing the clips again.

Very good to us UV resistant plastic. Otherwise in a few years it crumbles to bits, yes even behind the door panel.

definitely not from any charger, those are c body early 70’s.

Smell the steering wheel. Had it happen before. what was on the previous owners hands.

If your fuel and temp gauge are working fine then I would recommend leaving that system alone. The Chinese replacement parts aren’t better than the originals.

Scotchbrite is just like sandpaper, it will screw things up. So don't rub it on anything you don’t want scratched. Including chrome and aluminum. grime? Warm soapy water cleans that pretty well, try simple green if it won’t clean up With soap. evaporust works well removing rust, and it wont...

Yes follow above. There is a tang to locate the switch. Take the ring off and lubricate the threads first, it will make this job so much easier.

Just do the warm soapy water a few times first, then see what it does.

Can you imagine the last time that was cleaned? Decades? Try some warm soapy water and a microfiber cloth. Wring it out so it’s not dripping and wipe some soap and water on the chrome and dash. Let is sit a few minutes and wipe it off, repeat a few times. Let the soap do the work, don’t go...

Are they holders for push in clips to retain the board? Something like a door panel clip slides in them. what’s is on the top side of them?

1970 Fury

C-body only, 1971 & newer. definitely not B or E body

Yes like big john says take off the nut and the next nut Under it, it’s double nutted formthe ground wire. And you need to remove 3 bolts from the firewall (in red). The 2 in yellow do nothing for freeing the column.

Guaranteed delivery by December 2023

Thanks for the review, any living creature should wear gloves with these chemicals.

I can see a difference already. The center drop down has angled sides on the 66 and the 68 looks straight.

What doesn’t work? Did you try to clean them and lube them. Seems likely that they are seized up from non use and dirt accumulation more than both are broken.

M6T5 is your interior code is the same as every other 300 hurst. There is your proof in Chrysler documentation