Mick
Active Member
Well, bit the bullet and plunked down a chunk of change to have a " custom made"relay harness assembled for my Imp. I know it isn't that difficult, but I am...electrically challenged...
Anyway, they showed up in a reasonable amount of time. Directions were generic, but okay. Installed it, low beams worked, but no high beams. Contacted the vendor, we trouble shoot via email. He has me switch out the relays (there are three, I was instructed to switch the outer two). Bingo, the high beams switch on, but no low beams. He tells me this indicates bad relays.
SO, he sends out more, which I reinstall, with same results. Communication with the vendor is nearly non existent now, and I have no high beams.
Ideas?
Anyway, they showed up in a reasonable amount of time. Directions were generic, but okay. Installed it, low beams worked, but no high beams. Contacted the vendor, we trouble shoot via email. He has me switch out the relays (there are three, I was instructed to switch the outer two). Bingo, the high beams switch on, but no low beams. He tells me this indicates bad relays.
SO, he sends out more, which I reinstall, with same results. Communication with the vendor is nearly non existent now, and I have no high beams.
Ideas?