Connecting brake lines

[Drew-Pritchett]

1964 Chrysler 300k, I just updated my master cylinder to a dual bowl one. I have the front brakes plumbed by using the factory distribution block and blocking off the rear brake port with a plug.

Now my issue is I'm running a 7/16 brake line from the MC straight to the rear brake lines. However the rear brake line is a 3/16. For the life of me I can not find a reducer fitting, union, etc etc for 7/16 to 3/16.

Any suggestions? As always thanks guys!

 

[jbooth35]

I just went through something similar to this. One option is use something like https://www.inlinetube.com/products/ad9 and https://www.inlinetube.com/products/ad10 depending on your setup.

I used a rear proportioning valve in to join the rear line and am making a new line from the master to the rear valve and line from 3/16 line.

Hope that helps.


You'll

 

[Drew-Pritchett]

Yeah, that's what I was looking for, however I couldn't find one ANYWHERE, thanks bud!