robndi43
Active Member
It's been a while since I've been on the forums. Wife being sick takes precedence on my time.
I have scored a long ram sonic cross ram set up for the 413 at the Charlotte Auto Fair this weekend. I am wanting to install these on my '61 Newport that I'm slowly messing with. Is the throttle linkage available anywhere as a reproduction. I only got the two tubes themselves, and am going to start piecing together the rest of the parts to try and get it installed on my '59 Imperial 413 that I have salted away for my car.
I am going to need the balance tubes etc. if anyone know where I can find them. I am not in search of the special exhaust manifolds that are necessary to warm the carbs up with as I will engineer something else as I am going to run headers on the car. I have the AFB off of the '59 Imp motor and hope that I can use it as one of the two carbs. I'm going to start the learning process to see if that carb can be used as one of the two. I'll need to search out another one of those also. No rush on my part. Got more time than money to figure this all out. I've always admired that set up and wanted to have that on a car. It's on my bucket list anyway. I hope I can pull it off and make it happen.
Any education from the populace on here, I would be humbly grateful for.
Thanks to all.
I have scored a long ram sonic cross ram set up for the 413 at the Charlotte Auto Fair this weekend. I am wanting to install these on my '61 Newport that I'm slowly messing with. Is the throttle linkage available anywhere as a reproduction. I only got the two tubes themselves, and am going to start piecing together the rest of the parts to try and get it installed on my '59 Imperial 413 that I have salted away for my car.
I am going to need the balance tubes etc. if anyone know where I can find them. I am not in search of the special exhaust manifolds that are necessary to warm the carbs up with as I will engineer something else as I am going to run headers on the car. I have the AFB off of the '59 Imp motor and hope that I can use it as one of the two carbs. I'm going to start the learning process to see if that carb can be used as one of the two. I'll need to search out another one of those also. No rush on my part. Got more time than money to figure this all out. I've always admired that set up and wanted to have that on a car. It's on my bucket list anyway. I hope I can pull it off and make it happen.
Any education from the populace on here, I would be humbly grateful for.
Thanks to all.