I was going to update my strut rods to firm feel rods but they say you can’t use the stock sway bar links with them.
Both of mine are bent with the left side being the worst. I suspect someone put it in a ditch at some point because the sway bar to frame links are also bent and the lower valance panel is damaged badly.
Anyway my question is if I make some new ones on the lathe what steel would be best?
Thanks
Both of mine are bent with the left side being the worst. I suspect someone put it in a ditch at some point because the sway bar to frame links are also bent and the lower valance panel is damaged badly.
Anyway my question is if I make some new ones on the lathe what steel would be best?
Thanks