rapidtrans
Senior Member
After a month and a half email exchange with Waldron I give up. Their communication skills leave much room for improvement. After my initial inquiry asking, “do you have a dual exhaust system kit to replace my factory single exhaust system?”, and emails from them talking about “H” pipes, then lt. and rt. side exhaust pipes, I finally get an email stating,“we make the dual exhaust system”, then ending the same paragraph with, “We do not make a dual exhaust systems for single exhaust systems.” Confused?
Apparently, like TTI, Waldron only reproduces factory pipes not “conversion” to dual exhaust systems. Even though they do make the single exhaust system and they do know what manifold and flange arrangement are required.
Have any of you guys run across this?
So after calling around. Any number of local shops here can bend the tailpipes per factory cards then custom bend the exhaust pipes to manifold. I buy the hemi mufflers and over axle tailpipe hangers. They will install all for less $$ than Waldron.
Apparently, like TTI, Waldron only reproduces factory pipes not “conversion” to dual exhaust systems. Even though they do make the single exhaust system and they do know what manifold and flange arrangement are required.
Have any of you guys run across this?
So after calling around. Any number of local shops here can bend the tailpipes per factory cards then custom bend the exhaust pipes to manifold. I buy the hemi mufflers and over axle tailpipe hangers. They will install all for less $$ than Waldron.