WANTED 1973 C Body Disc Brake Spindles Or Later

Status
Not open for further replies.

racer383

New Member
Joined
Jul 10, 2020
Messages
11
Reaction score
3
Location
usa
Feedback: 1 / 0 / 0
Contact seller
I'm looking for 70 - 73 disc brake spindles. Doesn't matter what car they are from as long as it's a C body. I think 70 - 73 11 3/4" pin caliper bracket holes should all be the same.

Just send me a PM.... Thanks
 
Last edited:
I'm looking for 73 disc brake spindles or 74 - 76 will do also. Doesn't matter what car they are from as long as it's a C body. I think 73 - 76 11 3/4" pin caliper bracket holes should accept my 71 pin caliper brackets.

Just send me a PM.... Thanks

Get in touch with Craig here: @mobileparts
 
I'm looking for 73 disc brake spindles or 74 - 76 will do also. Doesn't matter what car they are from as long as it's a C body. I think 73 - 76 11 3/4" pin caliper bracket holes should accept my 71 pin caliper brackets.

Just send me a PM.... Thanks
I have the complete set up from a 74 Newport.
 
C Body Bob has cars.... I don't....
I do NEW ONLY --- I am in Long Island, New York ---
No cutting up of cars out here....
Spindles are USED only....
Not my department --- see C Body Bob.....
Yours, Craig.....
I have N.O.S. Asbestos Brake Pads , if you get what you want or need.......
 
C Body Bob has cars.... I don't....
I do NEW ONLY --- I am in Long Island, New York ---
No cutting up of cars out here....
Spindles are USED only....
Not my department --- see C Body Bob.....
Yours, Craig.....
I have N.O.S. Asbestos Brake Pads , if you get what you want or need.......

Ok thanks
 
I'm putting the heavy duty C Body brake system on a 1968 Dodge Charger with some mods.
Ok, my only thoughts on this is the lower ball joint on the cbody should fit if you taper drill the mount hole on your lower control arm. The 74 later spindles are different again as the ball joint is in the lower control arm.
 
Ok, my only thoughts on this is the lower ball joint on the cbody should fit if you taper drill the mount hole on your lower control arm. The 74 later spindles are different again as the ball joint is in the lower control arm.

I thought about tapering the hole if it isn't too much to where it weakens it. Thanks for the heads up on the 74 spindle. When I looked up the ball joint for it, I saw it was different.
 
Still on the hunt for 1973 C body disc brake spindles.
Where are you located? Stark Wrecking in Miamisburg Ohio has one 73 Fury and two 72's that still have the brakes on them. They had another 73 but its brakes are in my garage now :) . They will not pull them. You have to go there and get them yourself.
 
Where are you located? Stark Wrecking in Miamisburg Ohio has one 73 Fury and two 72's that still have the brakes on them. They had another 73 but its brakes are in my garage now :) . They will not pull them. You have to go there and get them yourself.

That's too far for me.
 
Status
Not open for further replies.
Back
Top